 |
|
|
B201M
sales@attinet.com
| The BRAT Option B201M is a general purpose missile test system utilizing Commercial-Off-The-Shelf (COTS) equipment in a modular design. The tester consists of two rack consoles to test pneumatic and electrical parameters respectively. The reconfigurable consoles allow easy access to all of the modules and room for expansion/ reconfiguring. The pneumatic console provides eight lines to the two independent gas supplies. The electronic console interface provides up to 450 pins of signal I/O and switching capability and 600 pins of cable testing capability. |
|
| State-of-the-Art-Technology | |
| The BRAT features VXI instrument-on-a-card and modular technologies to provide complex testing capabilities in a compact workstation. The pneumatic pressure and flow rates are controlled by a real time computer system that obtains pressure, temperature, and flow rates and adjusts valves automatically to obtain the desired settings. | |
| Electronic Valve and Servo Motor Testing | |
| The electronic console contains a Driver Simulator Module that provides precision drive signals that are monitored to provide measurement capabilities of servo motor slew rate, motor spin up time, and valve open and close times. | |
| Ordnance Initiator Device Testing | |
| The electronic console contains circuitry to safely test Ordnance Initiator Devices by using controlled currents. | |
| Precision Pneumatic Pressure and Flow Sources | |
| The pneumatic console uses Helium and Nitrogen gas sources to supply a pressure or flow through the gas interface lines. | |
| Pneumatic Console Specifications | |
| Helium Supply/Drain Lines | |
| Lines: | 2 source lines, 3 drain (options for additional lines) |
| Pressure: | 0 to 4500 PSIG |
| Flow Rate: | 0.84 to 60 SCFM |
| Nitrogen Supply Lines | |
| Lines: | 1 source valved to 3 lines |
| Pressure: | 0 to 250 PSIG |
| Pressure Regulators | |
| Range: | 0 to 4500 PSIG He, 0 to 250 PSIG N2 |
| Accuracy: | +/- 30 PSIG He, +/- 2.5 PSIG N2 |
| Filtration System | |
| Particle Size: | 2 microns |
| Flowmeters | |
| Pressure Range: | 0 to 400 PSIG He |
| Flow Range: | 0.84 to 60 SCFM |
| Accuracy: | +/- 0.2 SCFM |
| Metering Valves | |
| Resolution: | 1% increments of open |
| Rating: | 10,000 PSI |
| Shutoff Valves | |
| Rating: | 10,000 PSI |
| Electronic Console Specifications | |
| Arbitrary Waveform Generator | |
| Channels: | 2 output channels |
| Frequency Range: | 1.0 MHz to 25 MHz |
| Amplitude (1 Meg Ohm): | 20 mV to 22 V p-p |
| Amplitude (50 Ohms): | 10 mV to 11 V p-p |
| Standard Waveforms: | 8 (sin, triangle, square, pulse, pos ramp, neg ramp, arbitrary, DC) |
| Custom Waveforms: | 64K points, 12-bit data, 50 MHz data rate |
| Modulation Modes: | 6 (FM, PM, AM, PSK, FSK, PWM) |
| Relay Matrix | |
| Channels: | 192 channels muxed to analog test instruments |
| Voltage: | 200 Vdc max. |
| Current: | 1.5 A carry, 0.5 A switch |
| Bandwidth: | 10 MHz (192 chan) |
| Power Amplifier | |
| Channels: | 4 channels |
| Gain: | 1 to 10 |
| Output: | 90 V p-p max. |
| Frequency: | DC to 150 KHz |
| Digital Multimeter | |
| AC/DC Voltage: | Range: 30 mV to 300 V |
| Resolution: 10 nV to 100 mV | |
| Resistance (2/4 Wire): | Range: 30 Ohms to 3 G Ohms |
| Resolution: 10 m Ohm to 1 K Ohm | |
| Frequency: | Range: 10 Hz to 1.5 MHz |
| Period: | Range: 0.025 s to 667 ns |
| Sensitivity: | 10 mV rms (sine wave) |
| Rack Mount Digital Oscilloscope | |
| Channels: | 4 |
| Bandwidth: | 200 MHz |
| Storage: | 30K points per channel |
| Resolution: | 8 bits/12 bits in HI-Res mode |
| Time Scale: | 10 ns/div to 20 s/div |
| Voltage Scale: | 0.001 V/div to 10 V/div |
| Measurements: | 25 automatic measurements |
| DC Power Supplies | |
| Resolution: | 10 mV |
| Range: | 3 x 0 to 32 Vdc @ 6.25 A |
| 1 x 0 to 40 Vdc @ 5.0 A | |
| Driver Simulator Module | |
| Valve Driver Channels: | 2 each |
| Servo Motor Channels: | 2 each |
| Switch Motor Channels: | 1 each |
| Cable Tester | |
| Points: | 600 points |
| Insulation Resistance | |
| Source: | 500 Vdc @ 1 mA supply |
| Dielectric Strength | |
| Source: | 500 Vac @ 1 mA supply |
| Continuity Current | |
| Source: | 3.0 A supply |
| Measurements: | Continuity, insulation resistance, dielectric strength |
| Measurement | |
| Accuracy: | 10 bits |