Equipment

CNTX-1
Control Device (Requires ICSS Software License Agreement)
- Provides interface to BRAT tester and TPS (includes CPIN)

00002299-01
VSWR Adjustable Waveguide 

02200108-01
Air Data Test Set

  • Simultaneously measures an input pressure and controls an output pressure
  • Displays input and output pressure parameters as steady state altitude or airspeed or as rate of change of altitude or airspeed
  • Provides 2 pneumatic outputs (Ps and Pt)
  • Altitude can be displayed in feet or meters
  • Airspeed can be displayed in knots, MPH, ft/s, m/s, km/Hr, Mach
  • Pressure can be programmed or read in inches Hg, PSI, mBar, kPa
  • Static pressure (Ps) output has a range of 0 to 32.15 inches HgA
  • Total Pressure (Pt) output has a range of -0.5 to 73.55 inches Hg
  • Operates in local or remote mode 

02200207-10
Compressor/Vacuum Pump Case Assembly

02300521-10
Controller Case Assembly with Controller (BRAT 514A)

  • Used to position camera
  • Provides power for system
  • Provides communication from computer 

04000197-10
Switch Assembly

  • BRAT universal analog crosspoint switch assembly

05001000-10
Antenna Mass Simulator

  • Provides the capability required to test Antenna Servo Electronics systems

08010009-10
Liquid Cooling System

  • A liquid cooling cart for use with high power RF systems
  • Supplies liquid coolant
  • Remote On and Off
  • Coolant types:  Coolanol 25 or PAO
  • Coolant flow of 2.5 gal/min
  • Interconnecting hoses and cables

92103782-01
Waveform Generator

94100500-10
Electronic Power Control Center - BRAT with Rubidium

  • Power up sequencing of single-phase/3-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Monitoring of AC line inputs for dropout/reversed phases
  • Rubidium oscillator with 3 high-isolation outputs for common stable time reference 

94100500-30
Electronic Power Control Center - BRAT

  • Power up sequencing of single-phase/3-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Monitoring of AC line inputs for dropout/reversed phases 

94100500-50
Electronic Power Control Center - Single Phase

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets 

94100500-70
Electronic Power Control Center - RF Rack

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlet

94100500-90
Electronic Power Control Center - BRAT with Rubidium

  • Power up sequencing of single-phase/3-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Monitoring of AC line inputs for dropout/reversed phases
  • Rubidium oscillator with 3 high-isolation outputs for common stable time reference 

94100500-110
Electronic Power Control Center - BRAT

  • Power up sequencing of single-phase/3-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Monitoring of AC line inputs for dropout/reversed phase

94100500-130
Electronic Power Control Center - Single Phase

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets 

94100500-150
Electronic Power Control Center - RF Rack

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets 

94100500-190
Electronic Power Control Center - Single Phase with Rubidium (with Internal Drops)

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Rubidium oscillator with 3 high-isolation outputs for common stable time reference 

94100500-230
Electronic Power Control Center - Single Phase with Rubidium (with Rear Multi-Coax)

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Rubidium oscillator with 3 high-isolation outputs for common stable time reference 

94100500-250
Electronic Power Control Center - Single Phase with Rubidium (with Rear Multi-Coax)

  • Power up sequencing of single-phase power input to outlets
  • Elapsed time indicator
  • Emergency stop for removing power from configured outlets
  • Rubidium oscillator with 3 high-isolation outputs for common stable time reference 

94100604-01
Frequency Counter

  • CW and pulsed RF signals to 20 GHz
  • Frequency and power of repetitive signals down to 50 ns
  • Pulse widths from 50 ns to 1 second
  • Pulse periods from 250 ns to 1 second
  • Internal or external timing and control signals 

94100671-10
Waveguide Pressurization Unit and Blower Assembly

  • Super-dried compressed air at 15 psi
  • Forced air up to 270 cfm (free delivery)
  • Monitored outputs:  3 (blower pressure, blower air flow, compressed air pressure) 

94100671-30
Waveguide Pressurization Unit

  • Super-dried compressed air at 15 psi 

94101013-10
Phase Noise Measurement System Reference Source Unit

  • Generates RF reference signals in UHF, L, and X bands
  • Coherent UHF, L-band, and X-band outputs from external reference source
  • Simultaneous fixed-frequency outputs with individually controlled amplitude

94101013-50
Phase Noise Measurement System Reference Source Unit with Option 02

  • Generates RF reference signals in UHF, L, and X bands
  • Coherent UHF, L-band, and X-band outputs from external reference source
  • Simultaneous fixed-frequency outputs with individually controlled amplitudes
  • Increases the programmable COHO frequency coverage
  • Noise source injection testing
  • 2-tone RF signal generation
  • Increased programmable attenuation
  • Increased switching capabilities 

94101013-OPT02
Phase Noise Measurement System Reference Source Unit Option 02 - Broadband Upgrade
 

94101130-01
Phase Noise Measurement System

  • Measures phase and amplitude noise on both CW and pulsed RF signals at carrier frequencies between 10 MHz and 18 GHz
  • Measures absolute phase noise, additive phase noise, and amplitude phase noise
  • Measures noise at any offsets between 0.01 Hz and 40 MHz 

94101201-10
Logic Analyzer Case Assembly

  • High speed digital logic analyzer for use in analyzing complex digital waveforms
  • 102 Channels
  • 200 MHz State mode operation
  • 800 MHz Timing mode operation 

95650142-10
Three-Phase Power Distribution System

  • EMI/RFI filter
  • 14 Outlets
  • Remote power on/off
  • Circuit breakers for each phase
  • Rack mountable 

95650143-10
Single-Phase Power Distribution System

  • EMI/RFI filter
  • 8 outlets
  • Remote power on/off
  • Circuit breaker protection
  • Rack mountable 

96000169-10
1.2 MHz Low Pass Filter Assembly 

96000169-30
2.2 MHz Low Pass Filter Assembly 

96000170-10
1.9 MHz Low Pass Filter Assembly 

98715001-01
DC Power Supply

  • Resolution:  12 bits
  • Range:  1 x 0 to 600 Vdc @ 1.7 A 

98715001-03
DC Power Supply

  • Resolution:  12 bits
  • Range:  1 x 0 to 60 Vdc @ 16 A 

98715002-01
Relay Matrix

  • Format:  32 x 8 switched pairs
  • Voltage:  200 Vdc max.
  • Current:  1.5 A carry, 0.5 A switch
  • Bandwidth:  50 MHz 

98715003-01
Form C Relays

  • Relays:  48 Form C relays
  • Voltage:  220 V switch
  • Current:  0.5 A switch
  • Bandwidth:  50 MHz at -3 dB
  • Power:  1.25 KVA max. 

98715004-01
Rail Generator for 98715005-01

  • Levels:  4 output voltage levels, 4 input voltage levels
  • Range:  -4 Vdc to +7 Vdc 

98715005-01
Programmable Level Dynamic Digital Unit

  • Pins:  32 input, 32 output (options for additional pins)
  • Skew:  15 ns max.
  • Edge:  Resolution 100 ps, accuracy ±2 ns
  • Clock:  25 MHz pattern rate, 16 format clocks
  • Memory:  7 @ 64K each (output, 3-state, out algorithm, expect, mask, in algorithm, record)
  • Levels:  Programmabl

98715006-01
Variable I/O Module for 98715005-01

  • Output drivers:  32 programmable channels
  • Input receivers:  32 programmable channel

98715007-01
Static Digital Latch

  • Pins:  64 input, 64 output
  • Input threshold level:  Programmable -32 to +32 V
  • Output level:  Internal pull up to 5 V or external to +42 V (max.)
  • Output sink current:  250 mA 

98715008-01
Programmable Resistance Module

  • Channels:  1
  • Accuracy:  0.1%
  • Resolution:  0.1 Ohm
  • Range:  0 to 1 MOhm 

98715009-01
Phase Angle Voltmeter

  • Bandwidth:  10 Hz to 100 KHz
  • Voltage range:  50 mV to 300 V rms
  • Resolution:  5 digits
  • Accuracy - phase voltage:  0.08% @ 400 Hz
  • Accuracy - total voltage:  0.15% @ 400 Hz
  • Accuracy - phase angle:  0.10% @ 400 Hz
  • Current:  0 to 16 A 

98715010-01
Synchro/Resolver Simulator and Indicator

  • Channels:  1 simulator, 1 indicator
  • Frequency range:  47 Hz to 1 KHz
  • Output level:  2.0 to 90.0 V line to line
  • Accuracy:  0.003 degree
  • Resolution:  0.001 degree
  • Rotation rate:  0.0 to 1000 degree/s 

98715011-01
Power Digital to Analog Converter

  • Channels:  4
  • Voltage range:  ±4 Vdc or ±(0 to 40) Vdc
  • Resolution:  16 bits
  • Current:  0 to 300 mA 

98715012-01
Arbitrary Waveform Generator

  • Channels:  1 output channel
  • Frequency range:  1.0 MHz to 25 MHz
  • Amplitude (1 MOhm):  20 mV to 22 V p-p
  • Amplitude (50 Ohm):  10 mV to 11 V p-p
  • Standard waveforms:  8 (sin, triangle, square, pulse, pos ramp, neg ramp, arbitrary, DC)
  • Custom waveforms:  64K points, 12-bit data, 50 MHz data rate
  • Modulation modes:  6 (FM, PM, AM, PSK, FSK, PWM

98715013-01
Dual-Pulse, Arbitrary Function Generator

  • Channels:  2 pulse channels, 1 arbitrary channel
  • Frequency range:  10 Hz to 50 MHz
  • Amplitude (50 Ohm):  5.0 mV p-p to 22.0 V p-p
  • Pulse period:  10.0 ns to 1.0 s
  • Pulse width:  10.0 ns to 1.0 s
  • Pulse delay:  120 ns to 1.0 s
  • Rise/fall times:  3.0 ns to 150 ns
  • Modes:  6 (normal, trig, delay trig, burst, gated) 

98715014-01
Blower Assembly

  • Flow rate:  270 CFM @ 0" water, 160 CFM @ 3" water
  • Monitored signals:  3 (temp, press, flow rate) 

98715015-01
DC Power Supply

  • Resolution:  12 bits
  • Range:  1 x 0 to 300 Vdc @ 15 A 

98715016-01
Power Amplifier

  • Channels:  2 channels
  • Gain:  x 5 fixed
  • Frequency range:  DC to 18 KHz
  • Drive voltage:  65 V p-p
  • Drive current:  1 A
  • Output power:  100 W 

98715016-03
Power Amplifier

  • Channels:  2 channels
  • Gain:  x 10 fixed
  • Frequency range:  DC to 18 KHz
  • Drive voltage:  110 V p-p
  • Drive current:  0.5 A
  • Output power:  100 W 

98715017-01
Rack Blower Assembly

  • Flow rate:  320 CFM 

98715045-01
Blower Assembly

  • Forced air up to 270 cfm (free delivery) 

DCSS-10
Dual-Channel Satellite Simulator/Converter

  • Provides independent uplink and downlink functions between a 70 MHz IF carrier and UHF frequencies
  • Synthesized local oscillators allow frequency tuning while providing low group delay and flat frequency response
  • Gain and frequency control can be adjusted locally via front panel
  • Stand-alone instrument with remote Ethernet programming/control
  • Installed in a ruggedized case for lab or field use 

LPF-2009090
Low Power Filter Production

  • Contingent upon a total quantity of 700 or greater, in lots of 75 to 150