Products - Communication/Navigation

01000500-01
Dual-Channel Satellite Simulator
 -  Low noise RF output from -158 to -88 dBm
 -  Simulation of any GPS (NAVSTAR or GLONASS satellite)
 -  User uploadable NAV data with dynamic z-count for exact satellite simulation
 -  User control of Doppler velocity, acceleration, and jerk
 -  Outputs C/A code, code chip clock, epoch sync, NAV data, and NAV data clock
 -  Complete technical manual provided with calibration and maintenance procedures
 -  Full remote control via available LabVIEW™ driver
 -  Provision for external frequency reference
 -  Single-channel or dual-channel models available
 -  Input power: 100 to 130 Vac, 200 to 250 Vac, 47 to 63 Hz
 -  Rack mountable

01000501-01
Signal Generator
 -  Avionics modes supported: VOR, LOC, GS, MB, COMM, SELCAL, ADF
 -  Rear panel video
 -  Front panel control of video level for use with NAV converters
 -  Front panel store and recall: 49 setups per mode, 294 total
 -  Digital Signal Processing (DSP) assures stability and accuracy
 -  IEEE-488 interface standard - full bus control of all features
 -  FCC Type Accepted - for use in free radiation
 -  IEEE-488 Command Set compatible with Collins 479S-6A
 -  Output power range: -120 to +7 dBm
 -  Rack mountable

01000502-01
Navigation Support Instrument
 -  ATCRBS and Mode S Transponders
 -  Transmission and reception of Mode S Extended Length Messages (ELM)
 -  Transmission and reception of Comm-C and Comm-D Datalink Messages
 -  Two transmit channels for top and bottom antenna diversity testing
 -  Ability to simulate any Mode A, C, S, and Intermode Interrogation
 -  Ability to measure all key reply parameters: Pulse Timing, Power, Frequency, %   
    Reply, Squitter, etc.
 -  Distance Measuring Equipment
 -  Ground Station Simulation
 -  Velocity to 10,000 knots
 -  Distance to 400 nmi
 -  Ability to measure all key RF parameters and vary reply pulse parameters
 -  Power requirements: 93 to 264 Vac, 45 to 440 Hz
 -  IFF and TACAN
 -  Rack mountable

01000503-01
Audio Demodulator (Spectrum Analyzer)
 -  250 KHz to 1 GHz RF generator
 -  Duplex operation
 -  250 KHz to 1 GHz receiver
 -  10 Hz to 40 KHz AF generator
 -  250 KHz to 1 GHz spectrum analyzer
 -  1 MHz oscilloscope
 -  10 Hz to 40 KHz AF counter
 -  Digital data generator
 -  250 KHz to 1 GHz RF counter
 -  Rack mountable

01000503-03
Audio Demodulator (Accessory Module)
  -  Same description as 01000503-01
  -  Adds VHF and SATCOM testing capabilities, including Have Quick spread spectrum   
    options

03000004-01
Measurement Switch Module
  -  Routes UUT or communication/navigation generated signals to the specified test   
     instrument for the purpose of measuring the signals or UUT being evaluated
  -  Some signal conditioning circuitry and self test circuitry is also included in this module  
     to support self testing of specific signals under test

03000005-10
Noise Figure Meter with Noise Source
  -  Used to measure noise figures on communications receivers, components, etc.
  -  Provides a NIST traceable excess noise level such that the noise figure meter is  
     calibrated at the system level